Skip to main content

Apollo Lunar Module (LM)

Apollo lunar module free download 3d model solcommand nasa textured game ready low polygon count





Here it is guys, my take on the Apollo Lunar Module with a poly count of 18,773.
Enjoy ;)



 Here's more info on it taken from Wikipedia: The Apollo Lunar Module (LM), previously known as the Lunar Excursion Module (LEM), was the lander portion of the Apollo spacecraft built for the US Apollo program by Grumman to carry a crew of two from lunar orbit to the surface and back. Six such craft successfully landed on the Moon between 1969–1972. The LM, consisting of an ascent stage and descent stage, was ferried to lunar orbit by its companion Command/Service Module (CSM), a separate spacecraft of approximately twice its mass, which also took the astronauts home to Earth. After completing its mission, the LM was discarded. In one sense it was the world's first true spacecraft in that it was capable of operation only in outer space, structurally and aerodynamically incapable of flight through the Earth's atmosphere. Its development was also plagued with several hurdles which delayed its first unmanned flight by about ten months, and its first manned flight by about three months. Despite this, the LM eventually became the most reliable component of the Apollo/Saturn system, the only one never to suffer any failure that significantly impacted a mission,[1] and in at least one instance (Apollo 13's LM-7 Aquarius) greatly exceeded its design requirements by maintaining life support for astronauts after an explosion damaged the Apollo Service Module. At launch, the Lunar Module sat directly beneath the Command/Service Module (CSM) with legs folded, inside the Spacecraft-to-LM Adapter (SLA) attached to the S-IVB third stage of the Saturn V rocket. There it remained through earth parking orbit and the Trans Lunar Injection (TLI) rocket burn to send the craft toward the Moon. Soon after TLI, the SLA opened and the CSM separated, turned around, came back to dock with the Lunar Module, and extracted it from the S-IVB. During the flight to the Moon, the docking hatches were opened and the LM Pilot entered the LM to temporarily power up and test its systems (except for propulsion). Throughout the flight, he performed the role of an engineering officer, responsible for monitoring the systems of both spacecraft. After achieving a lunar parking orbit, the Commander and LM Pilot entered and powered up the LM, replaced the hatches and docking equipment, unfolded and locked its landing legs, and separated from the CSM, flying independently. The Commander operated the flight controls and engine throttle, while the Lunar Module Pilot operated other spacecraft systems and kept the Commander informed on systems status and navigational information. After inspection of the landing gear by the Command Module Pilot, the LM was withdrawn to a safe distance, then the descent engine was pointed forward into the direction of travel to perform the 30 second Descent Orbit Insertion burn to reduce speed and drop the LM's perilune to within approximately 50,000 feet (15 km) of the surface,[2] about 260 nautical miles (480 km) uprange of the landing site. At this point, the engine was started again for Powered Descent Initiation. During this time the crew flew on their backs, depending on the computer to slow the craft's forward and vertical velocity to near zero. Control was exercised with a combination of engine throttling and attitude thrusters, guided by the computer with the aid of landing radar. During the braking phase altitude decreased to approximately 10,000 feet (3.0 km), then the final approach phase went to approximately 700 feet (210 m). During final approach, the vehicle pitched over to a near-vertical position, allowing the crew to look forward and down to see the lunar surface for the first time.[3] Finally the landing phase began, approximately 2,000 feet (0.61 km) uprange of the targeted landing site. At this point manual control was enabled for the Commander, and enough fuel reserve was allocated to allow approximately two minutes of hover time to survey where the computer was taking the craft and make any necessary corrections. (If necessary, landing could have been aborted at almost any time by jettisoning the descent stage and firing the ascent engine to climb back into orbit for an emergency return to the CSM.) Finally, three-foot-long probes extending from three footpads of the lander touched the surface, activating the contact indicator light which signaled time for descent engine cutoff, allowing the LM to settle on the surface. When ready to leave the Moon, the LM would separate the descent stage and fire the ascent engine to climb back into orbit, using the descent stage as a launch platform. After a few course correction burns, the LM would rendezvous with the CSM and dock for transfer of the crew and rock samples. Having completed its job, the LM was separated and sent into solar orbit or to crash into the Moon.

apollo, lunar, module, orbit, surface, Saturn system, explosion damaged the Apollo Service Module, Apollo 13's LM-7 Aquarius,   moon, mission, outer space, atmosphere, unmanned, astronauts, cosmonauts, earth, 1969–1972,  Command/Service Module (CSM), lander,   rover, nasa, 3d, spacecraft, classic, old, US Apollo program by Grumman, model, free, Lunar Excursion Module (LEM), download,   solcommand, low-poly, game ready, lm, detailed, realistic, high-poly. high definition

Comments

Post a Comment

Popular posts from this blog

MCCV-2

Kitbash kit greeble lowpoly pack - 271 sci fi futuristic cityscapes and spaceship design

Kitbash kit of low poly greebles for sci-fi designs and futuristic concepts of spaceships, space stations and city rooftops.

TAU Intelligence